[dannichols1474]

This forum thread is long. Below is an updated table of contents to help you navigate thru it.



CIS to ITB EFI conversion: pg1 post 1-20, pg2 post 21-27

Brake conversion / weight reduction: pg2 post 28-30

Wiring improvements: pg3 post 41-42

Crankcase tear down: pg4 post 62-66

Heads tear down: pg4 post 68

Head stud removal: pg4 post 69

Engine wiring harness: pg4 post 72, 76

Parts cleaning / refinishing: pg5 post 81, 90, 96-99, pg6 post 100-105

Distributor modifications: pg6 post 106-107

Engine compartment seals: pg6 post 109-110

Engine lid seal: pg6 post 115

Rod and chain holder tools: pg7 post 126

Convert to moisture resistant connectors: pg7 post 129-132

Ground connections: pg7 post 136

Updated wiring diagrams: pg7 post 139-140

Piston weight: pg8 post 141

Engine air baffle modification: pg8 post 142

Updated sprocket supports: pg8 post 146-147

Piston / cylinder assembly: pg8 post 148-150

Fan, fan housing, alternator assembly: pg8 post 151-152

Deck height and compression ratio: pg8 post 153

Ignition timing set up - more info: pg8 post 154-155

Rod weight and piston/cylinder assignment: pg8 post 160

Crankcase clean and assembly: pg9 post 161-178

Valve train mock up: pg9 post 179

Piston to valve clearance: pg10 post 181

Engine assembly: pg10 post 182-194

Engine / transaxle installation: pg11 post 202-207

Camshaft break-in: pg11 post 209

O2 sensor controller calibration: pg14 post 263-266

Camshaft replacement: pg14 post 267-275

Final headers / exhaust fabrication: pg14 post 276, pg15 post 287, 292

Dyno tune / test results: pg15 post 295-296

Accel Enrichment Table: pg16 post 304

VE Table discussion: pg16 post 306-313

Rear decklid / front hood struts and rubber buffers discussion: pg16 post 316, 318-320 & pg17 post 322-323

Smoothie rear bumper fabrication: pg17 post 326-328



Hope you find this thread to be helpful.

Good luck with your DIY project!