|
Ok, I finally have some information to report. I received my CIS gauges from Pelican. After struggling to remove the air cleaner (could not loosen the right rear bolt on the AC compressor even with a crows foot) I finally resorted to removing the intercooler, I was able to hook up the gauge and follow the WSM procedures for cold, warm and system pressures. My pictures seem to be over the 5 mb limit so here is what they showed:
Cold control pressure:1.5 bar
Warm control pressure (after 5 minutes): 2.8 bar
System Pressure: 4 bar
These all appear low so I’m thinking my fuel pump(s) may be at fault. They both appear to be operating based upon the listening to them so I will test the output flow tommorow. Will advise.
|