|
There have been heat soak issues with the coil too - it is not in a favourable spot for heat soak.
May pay to try and swap a coil.
As for the rear clip on the dizzy... words fail most of us. But I have a simple piece of flat bar - about 10mm wide and 1mm thick - curved to slip around the back of the dizzy and flick that clip off. Special tool # 1234a. As for getting it back on - another story. But the flat bar does prop it up near where it is supposed to go, so I can flick the top of it in place.
Alan.
__________________
83 SC, 82 930 (track) - Stock except for RarlyL8 race headers, RarlyL8 Zork, K27-7006, 22/28 T bars, 007 Fuel head, short 3&4 gears, NGK AFR, Greddy EBC (on the slippery slope), Wevo engine mounts, ERP rear camber adjust and mono balls, Tarret front monoball camber adjust, Elgin cams, 38mm ported heads, 964 IC. 380rwhp @ 0.8bar Apart from above, bone stock:-)
|