|
Registered
Join Date: Dec 2002
Location: Dahlonega , Georgia
Posts: 15,063
|
Fastfred if you do a search on GM truck odometer failure you will see plenty of videos on the repair . There is a single row of about 8 pins soldered to the board . The failure seems to always be one or both end pins . In my case both end pins were missing solder . I assume a combination of poor solder wetting and/or cold solder joints .
It is a figidity repair but not hard . Small steady hands help along with a small tipped solder iron . My wife has soldered so much military hardware she can do it in her sleep . In regards to the bulb holders , if I ordered the correct sizes I plan to put dielectric grease on all contact points . Hopefully that makes them easier to install and remove in the future if needed . Good luck with yours .
__________________
2002 Boxster S . Arctic silver + black top/int. Jake Raby 3.6 SS engine " the beast ". GT3 front bumper, GT3 side skirts and GT3 TEK rear diffuser. 1999 996 C4 coupe black/grey with FSI 3.8 engine . Rear diffuser , front spoiler lip with ducktail spoiler .
|