The ring gear has to be more than 4mm in width, are you sure you didn't include it in the total measurement ? its important to know whether your measurements coincide with those of the OP otherwise we are just going round in circles, if it turns out that your overall measurements are the same as the OP's then we are back to square one!
In the meantime as the last poster mentions if the pressure plate bolts are not meant to have such thick washers under them, then removing them may be just enough, obviously I would still put a little lock-tight on each bolt just as a precaution.
Ant.
Quote:
Originally Posted by stownsen914
It’s worth noting that the ring gear added ~4 mm to the stack in my case. Jimmy if you measured them together then 29.5 mm is correct.
|