[Cloggie]

Getting on to final assembly and been attacking the various holes in the chassis bottom, underneath the car.

Some are easy, like the series of 8 mm holes underneath the tunnel, each of which needs a little plug to seal it.
Also the holes where the AC lines were fastened are easy to pick out - sealing them for the moment with the appropriate screw, rubber washer and steel washer.

But there are a ton of other holes in the chassis including some in the rocker panels (which I think need to be plugged) and at least 4 on each side underneath which are about 8.9 mm.

Question is, which ones need to be plugged and which ones are drain holes which ought to be left open?

I have been consulting PET, but it just says you need x of this plug without specifying where they go.

Anyone have an "under chassis map" for this?

Thanks!

D.