|
if your looking not to see the chips though the new paint your going to need to feather edge the chips out. most likely you will need to sand it with 180 grit then a few coats of primer sand the primer with 400 or 500 grit then top coat with the paint.
depending if your top coating with base or single stage your final sanding grits could change.
for base clear I would opt to sand it with 500 or 600 grit.
for single stage 400 or 500 grit.
if your going to use a wet on wet sealer before your going to top coat you could also do your final sanding up to a 320 grit.
|