You have to swipe the magnet close to the rear of the sensor while watching your ohm meter response, its a bit fiddly to get the right orientation of the magnet, but if the sensor is ok, you will get the switch to make or break with a good strong magnet.
Ant.
Quote:
Originally Posted by Sliver911
Installed new sensor correctly and no-go. Cannot seem to get any ohm readings while either out and running a magnet or installed and wheels turning. I used a metal pickup wand magnet and it does not register. Going to with ordering another sensor with the assumption it is bad (it’s a Uro) and on from. There
|