Quote:
Originally Posted by Flat6pac
Read the instructions on the tube, three bond, Yamaha bond, etc needs to be applied both sides on flanges because the products skin over so quickly it won’t seal to the opposite flange
Bruce
|
We
never coat both case halves. There is no way to apply the products to both halves without creating excess squeeze out. Although the TB products and now the Dirko we use both have exceptional break-away retention, too much squeeze out will leave the risk of the excess breaking off ans traveling through the engine.
This break-away residue can easily clog bearings, piston squirters and cam oilers.
The key is to simply set up your assemble parts so when you're ready to put the case halves together there is no delay.
Make sure your case through bolts are ready (o-rings installed and lubed) the #8 saddle have a thin smear of 1211 and your oil pump seals, main seal, chains and rods are positioned for quick assembly.