|
3.2 911 not starting
I know there have been many threads on this and I have read lots of them but I am still not able to figure my car out.
Ran fine 2 weeks ago. Was going to drive it yesterday and it started to start for about 1 sec then died. Since that initial start attempt it does nothing but crank.
Battery voltage is good.
38psi when I testing at the driver side fuel rail.
At least spark plug 1 is getting spark with a spark tester
Idle control is humming
Pin 87 of the DME relay do show good voltage with the key on.
Pin 87b show good voltage under while cranking. (jumped out pin and can hear the full pump running)
Metered resistance on the 2 black plugs on drivers side intake manifold. From my reading these are the reference and crank position sensors. Both metered at 996 ohms.
Car cranks fine but never sputters or does anything other than make the garage smell like gas.
I have not pulled a plug yet to see if they are wet. Going to do that soon.
Please show me the error in my ways or what I am missing. And of course what I should check next if I haven't missed anything obvious.
Thank you.
Foster
__________________
Foster
Monroe, Ga
1984 911 Carrera Targa
|