|
not sure what door skin camber is???
a door skin replacement is pretty easy.
if your replacing the skin of a door this from the car already it's even easier as you have the original marks from where the door was on the car.
I do most of the skinning of a door on the car then remove it and finish folding over the edge.
I also use door skin adhesive on the inside edge of the door shell to help keep moisture from getting between the skin and shell.
the door skin should have a bit of play in it so you can get a proper gap along the rocker and up the QTR panel as they are not adjustable o its setting the gaps there is important.
tke your time folding over the edge of the skin and go around the whole door edge folding the skin a little at a time.
once the skin is on the door I will put a few tack welds back on the lip of the skin to the shell .
if your going to also use a door skin adhesive do not put the adhesive between the outside of the door shell and the inside of the door skin.
|