Quote:
Originally Posted by tabasco
Nice job! Would you share the file for the base plate?
Did you print it in several sub-sections, or did it fit in the X1?
|
It was a single print, barely fit in my Bambu X1, but no issues.
There was some plate adhesion issues so I had to put some extra brim on it and the final prints came out fine.
Not sure if I would dare using PAHT-CF on an open bed printer, it prints pretty hot and judging from the warping I had, it really wants to make it bow shaped once it gets more than about 5 or 6 mm tall.
The PAHT also is not a smooth print, but it sands well and my intent at some point is to sand/high build primer them and then put a nice coat of SEM Trim Black on them so they look good.
Yes, I will share the .stl if anyone wants it...and would be willing to print out a set or two if people wanted to buy them, but since I am on the way back home (I spend part time in Canada, part time in Europe) I won't be able to print them up until close to Christmas.
Oh yeah, you probably did not see the little ABS clips which snap on and retain the air cleaner. They seem to work well, but we shall see.
D.