[Coultl]

Lastly, I pressure tested the intake with intercooler to 25 psi. It should handle that with ease but it was still quite terrifying. Using soapy water I did observe that many of the seams of the 3D print were not 100% air tight. It’s not enough to be an issue but I’m going to try to seal it up anyway. Will follow up with how that goes.

Those small bolted on parts on the back are just block off plates. I added ports for the intake the air temp sensor in three locations. I don’t think I’ll use the ones on the back but they make for good inspection ports as my borescope fits in the hole.

Hoping to finish and paint next weekend!