Quote:
Originally Posted by soxnail
Slightly different question, I pulled the water temp sensor to do a bench test on it (not conclusive, but definitely of at 212 boiling point).
My question is : when I pulled the sensor out no coolant came out, I could see see it sitting right at the rim of the sensor mount hole but since this point is lower than the vent hole should there not be some coolant coming out of the sensor hole?
Thx Sox
|
Been traveling so a little time off.
I think I need to address the issue stated above. If no coolant comes out of the temp sender hole then the level must be low correct ? But I cannot put more coolant in without it just coming out of the bleed hole.
As far as I can tell the sender hole is below the bleed hole so how is this possible ?
Need some one way smarter then me to answer this.
Thx Sox