|
into the type 1 tranny? what year car? what year tranny?
if it's a 6 volt, a little grinding may be required to let the bigger flywheel clear some tight spots.
I used European Motorworks, in Los Angeles.
call them up and tell them what you are doing. they gave me a 210mm bus flywheel, sprung clutch disk, and a special PP with a "collar" for the TO to ride on. If you order with them, be specific about which TO bearing you want, they gave me the wrong one, but I sent is back, no hassles, and had a check two weeks later.
with the 210mm instead of the 200mm, you have a lot more area for the friction disk. This means that you don't have to have a super strong PP. besides, my setup cost about as much as it would have for just the KEP 200mm flywheel, not to mention one of their stage 2 or 3 kits.
what is a sharpbuilt pilot bushing?
------------------
Kokanee
'64 Manx 2.0L
[This message has been edited by kokanee (edited 03-01-2000).]
|