[Dan Owens]

Guys,

Kach22i, The plastic pin covers are a pain in the Ass to put one but not impossible. I used a hair dryer to warm them up and make them a little more pliable. Hot water would work too. The issue is that the pins have two groves (if I remember correctly) in them and the covers have two ribs on the inside that mate up to them. You have to get the ribs to pop over the first set and seat into both. I may have this reversed but the result is the same. Don't squeeze the sides of the plastic cover when you're grasping them to put them on the pins as this just locks them from going over the rib. Push them from more on the pointy end of the cover, with a small tap to pop them on. Hope this helps.

Tom Ratza, on your issue I'm not sure exactly what you're saying as you could be describing two different things here but here goes. The side rubber seals on the targa top can be moved or position left and right to adjust up to the window. There should be three or four holes in the underside of the side seal strip that if you slide a philips screwdriver into you can loosen the whole seal and slide it up against the window and then re-tighten the screws. The second thing is I'm not clear on if your window is going up all the way to the top leaving a gap between the top of the window and the bottom of the seal. If the window isn't going up all the way there are window stops inside the door behind the panel that can be adjusted to correct this.