|
Rick:
You might try drilling holes in the concrete with a hammer drill and masonry bit. Use your compressor legs to mark the holes. Then just get some all-thread (threaded rod) maybe 3/8ths to 1/2 inch - whichever you decide to use. Drill smaller starter holes to start with & then drill them out to a bigger diameter than your rod. You can use quick drying cement (Readicret - sp?) to anchor the rods. Then you could put a thick rubber washer under each foot & one on top to anchor the compressor & compensate for some of the vibration.
__________________
Marv Evans
'69 911E
|