|
I would rather be driving
Join Date: Apr 2000
Location: Austin, TX
Posts: 9,108
|
I think if you could post pictures and directions of where and how you removed material that would be helpful. For example, did you mill, file, dremel, sand, etc to shave the weight? Same for the rod, pin and piston locations.
Just more data for everyone on the board. Did you make a jig to measure rod end weights? I assume that you balanced each rod end and then removed a bit from the middle (near COG) to balance overall weight
__________________
Jamie - I can explain it to you. But I can not understand it for you.
71 911T SWT - Sun and Fun Mobile
72 911T project car. "Minne" - A tangy version of tangerine #projectminne
classicautowerks.com - EFI conversion parts and suspension setups. IG Classicautowerks
|