After reading through a number of posts on the board I have decided to go ahead and replace the CV boots on my 83SC. I noticed one on them has a small tear and grease is starting to get sprayed up underneath the car.
This will be my first DIY job on the car.
Most of the posts indicate that its not a very hard job, but is very messy. I will replace all the boots and repack the joints with new grease.
I think I need the following tools for the job
Torque Wrench (will torque bolts to 36 ft-lb)
6 mm hex to remove bolts
Some of the diagrams show a cir-clip. Will I need a cir-clip remover????
Please let me know if I have forgot anything. I will keep you posted on my progress.
