|
Bezel question?
Not sure why the Haynes manual calls it that, I think we call it the aluminum trim pieces that holds the front and rear windows in place.
Anyways, front window is in or it at least appears that way. The seal is catching the lip all the way around so that is a good thing.
But...
I did notice that the window is tight all the way around except for in the middle. there is a bit of play if you push in on it, though the rubber seal is catching the frame. Well, investigating further I noticed that where I have the little bit of play, is also where the two pieces of trim meet in the bottom middle. From where they meet to about a 1/4" from the center on both sides the bezel popped out of the seal. Should I be concerned? Is there anyway to get it back in with the window on the car. I don't think so but what do I know. Any suggestions?
What about the glycerine that I used where the seal meets the car as suggested by the Haynes manual. Will that dry up and tighen the seal?
Thanks,
David
|