[Drago]

I liberated an old mild steel drafting table base from Boeing Surplus. For the top I used two sheets of 5/8 inch particle board screwed and glued together. For a protective covering I again liberated a roll of .040" 2024-T3 aircraft grade aluminum sheet from Boeing surplus. Epoxied the aluminum sheet to the particle board with about 2 inches hanging over. I then took a hammer to the overhanging edges and bent them around the edge of the particle board sandwich and screwed the free edge to the underside of the top. Took a orbital sander w/ 80 grit to the surface and roughed it up.

Sorry, no pic's.