[gestalt1]

from what i've read the deck ht should be between .8mm and 1.2mm. i was not planning on actually measuring the volume the traditional way but i think it might be a good idea now. i think i will do my valve clearence check first however - if the valves are to close then i know piston machining is required. the other problem is that the chamfer on the heads is a little (.5mm) over the size of the cylinder. i posted about this and got a 50/50 opinion on this. i feel that since there is a small chamfer on the cylinder top that a small groove is created anyway and i should be ok. i was hopeing the computer model would be good enough but measure twice, cut once as they say.