|
Registered
Join Date: Jul 2002
Location: Canberra Australia
Posts: 440
|
Exhaust port and HE diameter
OK so I though that I had everything sorted out with my heads. UNTIL........I mated the SSI's up to the exhast ports to check studs lengths.
The heads have had a lot of work done to them and it looks like the PO has, among other things flared the exhast ports out from 35mm to 40mm. So the situation is that the SSI's will now create a step of 5mm.
What is the concensis on this...leave as is or flare the SSI's out to 40mm. I do not know if this can be done or not without effecting the integrity of the joint. Any advice would be most welcome!
Thanks
Mark.......
|