Hello
Did you center the clutch ?
Sometimes they come very hard together as the starter gear ring is very close to the clutchhousing and any missangle will make it stick.
One trick is to engage a gear and turn the trany axle shaft while blocking the other.
An other helper must guide the trany and press a bit from the trany frontend,
If this aint work then remove it again and look close. Any thicker scrafing inside the bell housing ? Clutch aligned not to much grease in the needle bearing ? Staterring pointing inwards ? TOBearing fork ok ? Removed the big TOB lever on the underside ?
If everything is proper then it sometimes stick very close to the end. Then use two nuts the frist at the stud from the starter and bolt it carefully on.
To go sure you can remove it again and check again then return musst be easyier ( If you hit the right 0° angle )
Grüsse
|