[p911sc]

Brilliant. I had pictured the rear connection at the mounting bar but was looking to lift the engine to the yoke, rather than mounting the yoke while the engine was on the ground. That should do it.

Thanks for the quick replies.

Another question, when removing the studs, I will use a propane torch to heat the case and melt the locktite. I am concerned about overheating the case at the point of the flame. Is this really a concern or does the propane burn at a low enough temperature that I shouldn;t be concerned??

Rick

P.S. I think I will also take the advise on the beer and pizza.