|
Registered
Join Date: Sep 2005
Location: Holly Springs NC
Posts: 262
|
ok going down the list.
with key on there is voltage at both terminals on the coil and one of the pins on the injectors. therefore ignition switch and dme relay are ok.
voltage at both but no spark. reference sensor was adjusted properly by a glued washer to the speed sensor(.8mm +- .05mm washer)
coil, distributor cap/rotor, plug wires are all brand new. fuel pump relay is brandnew. pin on flywheel was still intact. timing belt is fine (engine was cranked manually by hand and by starter and tdc was still preserved)
conclusion:
1 possibly sensor harness wiring
2 dme
how would i check to see if the dme is ok? i'll check resistance between the reference sensor and the dme.
__________________
85 (early) 944
78 sc targa
"The fool who wades in doubt will float like concrete"
Last edited by mcguiver7; 06-01-2006 at 06:58 AM..
|