Thanks, it can be fun, it can also be a pain.
As promised more hacking and cutting photos.
Thinking of adding more surrounding supports (aluminum). I have to get the air flow sculpted much better than it is now at the bow, just starting the process.
I thought I only had a couple air holes each inflated sponson side to seal up. I can see where I need to seal up many holes, don't need the air in the sides, need to get it out the front and under the craft.
Tweeking may not cut it, but it will help. I'm more or less set on replacing the drive/lift fan. Plastic gets old and breaks down with age, probably a good thing to replace every 17 years, right?
I mean car tires should be replaced every six years no matter how many miles on them, right?
