I am looking at adding a Bridgeport mill to my tool collection. The problem is the door into my shop is only 32" wide and the mill won't fit through the door with the table on. So how hard is it to remove the table? What step do I need to take in taking it apart and putting it back together? I have used the Bridgeport many of times but never disassembled one. Please advise...
Thanks in advance,
Speedy
__________________
1983 944 guards red with 16" Fuchs, Host of Wisconsin area timing/ balance shaft belt tensioning party
1987 944S Purchased from Legion. Corvette LT-1 V-8 conversion with Mega Squirt II
Check on progress --->
www.porschehybrids.com/gallery/speedracing944
Favorite Road =
www.tailofthedragon.com 318 turns in 11 miles (11 min 20 sec best run)