|
You may need to remove the back shelf or parts of it to get it to come out easily...
But undoing the engine is just 4 bolts. 17mm IIRC. The rest of what you see are for the trans/clutch/etc. Get the engine supported, undo the 4 bolts, pull engine to the rear a few inches and its off/disconnected. Then its just a matter of angling and pushing back and forth to get the engine down and out. You'll want the car raised, but not on an angle. You'll want to watch hte heater horns (disconnect heater control rods too!) and you'll need to tilt the engine to get the horns past the torsion bars.
__________________
“IN MY EXPERIENCE, SUSAN, WITHIN THEIR HEADS TOO MANY HUMANS SPEND A LOT OF TIME IN THE MIDDLE OF WARS THAT HAPPENED CENTURIES AGO.”
|