View Single Post
Mike D. Mike D. is offline
Registered
 
Join Date: Nov 1999
Location: Santa Clarita, CA., USA
Posts: 169
Garage
FS: 68 2.0 911 engine - SOLD

Engine is Sold - Sorry Can't Delete for some reason????

68' 2.0 911 Engine, Rebuilt, Less than 4000 miles. (914 oddometer) Has L cams (similar to E), E pistons, Bosch E distributor. Short Stroke. 7000 rpm. 130 HP. Seat of the pant feels like more. Once had a Porsche mechanic tell me it felt like a 2.4!

Currently running in my 914, so you can come and drive it or send someone for a ppi. My 914 is weekend fun car and gets driven on Fun runs and I have done 3 AX with this engine sense I did the install about 3 years ago.

Oil system is -12AN and comes with a 914/6 oil cooler (if you want 911 cooler it can be swapped out)

901 flywheel.

Webber 40mm Carbs. with K&N and rain shilds, linkage (you will need to get other 914 linkage parts) PMO fuel bar, PMO heat insulators.

Comes with Jacobs plug wires (not the firebraid in picture)

New Performance Products sump Plate

Silicone Valve cover & sump gaskets

Hydraulic chain tensioner emergency stops.

rebuilt Alternator (for external regulator) perfect for 914/4 realy board

wire harnes and I can give you a wire diagram that I created for my instal

MSD coil

Has always been run with external oil cooler and thermostat.

complete engine ready for your 914 or early 911, you need engine bay tins (911 or 914), mount, exhaust, oil tank and lines, ignition.

$3500. obo

Can also sell with out the Webbers and/or ??? whatever you need. Can also do swap into your car if you have parts.

PM with any questions, I have probably forgetten some details.
__________________
-Mike D.
'74 914-6
'94 968

Last edited by Mike D.; 03-21-2007 at 08:32 PM..
Old 02-27-2007, 09:22 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #1 (permalink)