I'm running an extra leg off my existing natural gas line for a grill. While apart I decided to replace an older T fitting because a reduction bushing was used and that is not within code (I probably should have left it alone).
Here's where I need advice. After replacing the T with a properly sized piece I need to replace the "bridge" between the two lines. Unfortunately running pipe requires a consecutive assembly. So, how can I "splice" this piece in and maintain a good seal?
Is there a shutoff valve with one reversed thread so when I tighten it it pulls each side in for a good connection?
Below is a test fitting. The older pieces will be replaced with new. Also, while it looks cock-eyed in the pic the assembly is actually straight. (Yes, that is gas rated tape)
