1983 911SC - replacing throttle bell crank bushings seemed easy enough ... not!! I removed the bell crank, the old bushings fell out and I tapped in the two new bushings - whoops, because the new bushings ID was smaller, I could not get the bell crank back on the shaft - had to Dremel the inside bushing out and then reinstall by replacing the bushing on the throttle shaft first and then slipping the bell crank on to the new bushing with a few taps.
Beware - easy job made difficult - install outer bushing in the bell crank shaft and replace the inside bushing on to the throttle shaft and then slip on bell crank.
Thought someone my want to know.
Goosh
