[djb25]

Hi everyone,

I'm converting my 2.7 to EFI, and I'm currently in the process of building a new intake for the car. I'm trying to keep the existing CIS system intact (and also on the car until the EFI is ready to install).

Anyway, if someone has a 911 engine sitting around without the intake on it, I need two quick measurements:

1) From cylinder to cylinder, across the engine (say from #3 to #6) and

2) Either a triangulation of the intake studs, or a measurement of the angle from one stud to another.

I know my descriptions are terrible, I wish I could find a drawing showing... exactly what I'm looking for.

If I find one, I'll post it.

One other question - would the exhaust ports/studs be the same as the intake? If they are, I could just take the measurements myself...

- Damion