|
Registered
Join Date: May 2004
Location: Encinitas (San Diego CA)
Posts: 4,495
|
You can use spacers or make a "bubble in the rear window shelf. I did both 1/2" spacer and a bubble. My car is very low and I didn't want the engine hanging down below the car too much. I had the car on a lift and used a 4x4 with a floor jack to "bubble" the rear window shelf. It is not obvious with the RS carpet kit installed. The bubble is probably 1.5" at the peak and maybe 18" x 10" with a gentle curve.
If you run the single crank pulley (patrick motorsports or other), you can back-date the rear cradle mount and crossmember. (As shown by Ted and Bill).
Doug
__________________
1971 RSR - interpretation
|