[Vincent 911]

I am done with engine rebuilt on my SC. I am currently working on front brakes, new Bilsteins, turbo tie rods.
I recently found a leak on the passsenger output shaft of my transmission. So I need to change it.

Here is my question: whats is the procedure to replace the 915 gear box output shaft seals?

Do I need to remove the big nut of the transmission shaft on the wheel side (I believe it requires a 36mm socket and a lot of torque)

I did not found any post which mentions the procedure to change this seal and I don't think it is in my 101 project.

Thank you