|
Picture an inverted U made of construction lumber (2x4, 2x6, 2x10's etc.), essentially a moving dolly but taller to accommodate a floor jack under it. Install heavy duty caster wheels at the four corners. Make the platform a little narrower than the distance between the control arm pivot points. The heat exchangers will rest on the platform to provide L-R stability.
Make the fore-aft dimension of the platform long enough to balance the drivetrain (engine/gearbox); about 18" will do.
Position a floor jack under this rolling U-shaped carrier, then raise so it supports both the gearbox and engine. Once the drivetrain is free, lower the jack until the caster wheels support the weight. Remove floor jack, then roll the drivetrain out.
I understand the commercially-available jack adapter works well too.
Hope this helps,
Sherwood
|