Quote:
Originally Posted by 1411506
Starter is fine - I hooked a jumper cable to the pin on the second connector corresponding to the yellow wire and turned the key to the cranking position.
|
Rob,
Hmmmm. You shouldn't have to use the ignition switch. Connecting source voltage (via the battery terminal on the starter motor) to the solenoid #50 terminal should energize the solenoid by itself; no action needed at the ign. switch.
If the engine cranks with this temp. jumper connection and doesn't with your ignition switch, I'd suspect the switch (at least at the #50 crank position).
Sherwood