|
when I emotionally recover I'll post my puller parts/etc. I ordered 2 more bearings...I hope the Pelican FAG bearings are as good as the SKF original..
Let's see if I can be smart and not mess up this time.. I'll try freezing the hub next time and warming the arm with bearing... this should help start the hub deeper... when I put the hub in at room temp. it grabs right away. I pulled then spun it to see where it is high... then pushed the puller over and it pops in... then crank a bit more, spin and adjust.. this reduces the binding as you pull in the hub. I was only pulling on the rear inner race. So I was getting real good at this and feeling smart... then noticed.. "how am I going to get those other parts on"... dang.
|