|
yes, your car may be different than mine... to pull the bearing out you can pull on the inner race..
I don't know why the 3" conduit coupler was mentioned somewhere... the 3" conduit coupler should fit inside the hole in the arm... on my car the hole in the arm on the back is 74.75mm.
If you use a "thin" section back there I don't think it will grab the outside race of the bearing, it just pushes on the seal... which IMO is not so great, better to push on the inner race. Your not going to reuse the bearing anyway.
If you check my diagram above you see that you can't get at the outer race. ID of the outer race is about 75mm and the hole is 74.75mm, so you can't get to the outer race.
|