OK< here are a few pics of the RHS duct. As I said, the LHS has some issues, so not sure what I am doing there yet.
The uncut duct still in place...
the PVC pieces being used (about $5 worth)...
the hole has been cut. I thopught about using this grommet instead, but bagged the idea as my hole is low enough (to get the tubing as low as possible under the AC Compressor) that the grommet had clearance issues and would not work...
Everything epoxied into place. Not sure if I am going to use the small extension PVC piece into the shroud area or not. I had to cut the 2 inch 90 so that it would not protrude in the shroud cavity when expoxied into place (for clearance again)...
The grabage you see is part of the paper that came off when it had cured enough to move it...
The epoxied piece in for a trial fit...
As compared to the early tin Jon sent me...
Still need to clean it up and paint, but need to wait til it fully cures.