[bleu951]

I cannot tell you were they go, but maybe this will help. you can connect them up and check for continuity before applying battery voltage.

Pin 30 4.0 red wire
pin P 1.0 grey wire
pin X 2.5 black/yellow stripe
pin 15 2.5 black wire
pin 50 4.0 red/black stripe
pin R 1.0 red/black stripe

switch positions off, R (accessory), 1 (run), 2 (start)

pin 30 is battery voltage, hot all the time
pin 15 is switched battery voltage, hot only in positions 1 & 2
pin P is hot in positions off and R
pin X is hot in positions R and 1
pin 50 is hot in position 2, starter solenoid
pin R is hot in all positions except off

Numbers like 4.0, 2.5 are metric wire gauge in square mm's.