[OldTee]

I may have an assembly problem and could use a little advice. My right side cam may be binding. I cannot turn it by hand. I used a ratchet and cam socket to get it moving the first time and it felt smooth thru multiple 360 degrees, but still would not turn by hand. I am not strong enough to overcome the break-away tension. The left side does turn by hand. Before I take it apart and start over I thought I might get some opinions.

Some history on this engine. One of the reasons for the rebuild was a unresolved hot running condition. One bearing showed some wear, but no heat indications. The cams were reground by Camgrinder and did not show stress when removed.