[ONQRACIng]

We have the MoTeC set to a modest 7600 limit, but the dyno runs were in the 9's to see peak HP and TQ. I am running 964 cams which have about as large a lobe as will fit in the cam towers. the Compression is 14:1-1 but we are adding a shim to give more than a mm clearance, so we need to recalculate, SB around 13:1-1.

The pistons are JE that CMW machines the dome and valve relief for our spec.

Full race, running TMW ITB's 3003 (undersized) off the 2.9 for now. Headers 1 5/8into SuperCraps.

Very reliable, RPM is limited to keep meantime between rebuilds down. We get about 35 hours out of a top-end..

Both are torn down for winter rebuilds as we speak.

Hope this helps..
Andrew