Quote:
|
I am running 964 cams which have about as large a lobe as will fit in the cam towers.
|
Umm, not really, you can fit a .525" lift camshaft into a cam tower without modification. You can fit a .580" lift cam with an offset lobe. Both are much more than a 964 cam which is fairly small.
I have had experience with the CMW heads and I would not use them for paperweights. They machining is some of the worst I've seen and unfinished to the point that the sharp edges cut my fingers. The bigger is better philosophy that CMW uses (port size and valve diameter) is old school and does not work as well as newer technology available. I have flow bench data for flow and velocity on the heads as well as some dyno work. Not worth the money.