|
So you wanna see der engine
1) retract top to a point where the top attachement handle (leading edge of top) is about 10 inches back from its attachement point.
2) Gently lift the back of the top up to expose the twin ball joint cords (Note:One on each side of top) firmly grab the ball joint and pull awaythe female end from the male end.Do this on both sides
3) If you have the DSP rear speaker box. Go to the passenger side and locate the wire harness attachement (It comes out of the side of the box and the attchement point is behind the roll bar)
4) twist off the two pull tabs on top of the speaker box. Lift out of the way.
5) remove the sound proofing/carpet away.
6) Engine lid: twist off the 6 D-ring handled screw tabs.
7) ENJOY THE VIEW!
|