[Buckterrier]

Mike, I can give you generic instructions on putting film on a surface.
1). Clean area well with a grease wax remover
2). Lay the script where you want it and mark with pieces of tape, (outline the area).
3). Add a little, a few drops, of baby shampoo to luke warm water.
4). Remove the paper backing and wet with the lightly soaped water. Doesn't hurt to wet the substrate either.
5). Place the script in the area previously mark. Using a bondo squeegee push the air/water bubbles from under the film.
7). If you have any tiny air bubbles left you can use a pin to pop the bubble and press the air out. You'll never see them.

I'm sure others will chime in with other recommendations. Good luck and post pictures of your work!