|
The resistance from the DME relay to the injectors was 0.3 ohm with the DMM internal of 0.2 ohm so the would be 0.1 ohm through the circuit so I think that connector is good as we measured through it end to end.
I've looked through the DME controller schematic, please check the resistance between pin 18 of the DME controller to the DME relay, pull the controller and relay. It appears to be the one that supplies power to the injector transistors in the controller. I think it goes through pin 3 of the 9 way that Laponnia mentioned, there should be a 2.5mm red/yellow wire going in and two 1.5mm red/yellow wires coming out.
Last edited by MikeStewart; 01-13-2009 at 06:48 AM..
|