|
All done. After glancing all around the garage and elsewhere for something the right diameter to drive in the races...it hit me....how about the old races.
So I set the old race on the new race mirror image, put a small board on top and tapped in the new race a little ways. It doesn't go far before the old race starts to go in and get stuck. So I pull the old race out and turn it over. This allows it to go in further before it gets stuck, and also it gives a lip where the bottom diameter of the old race is slightly smaller than where it butts against the new race. Once the new race is nearly seated you can turn the rotor over and tap out the old race by putting screwdriver on the lip and tapping it with a hammer, being careful not to scratch the new race. Then the new race can be tapped alternately on each side with a screwdriver the last little bit. It sounds a little complicated in words but there's nothing to it in deed.
Oh, and I did the bake the rotor, freeze the races routine first.
Thanks to everyone for ideas.
Kerry
|