Quote:
Originally Posted by afterburn 549
The tool is a jig thing so you can safely run a drill dwn through the guide , remove most of the material and then it taps right out.
Going back in you want a bunch a heat for a hour or so .
.( I would have to look up the temp gain ..maybe 400 deg? )
like I sad I reheated mine after installation too.......just in case any thing wanted to move after the 1 st heat cycle
|
400 deg Fahrenheit, Celsius not i guess
i have heard about 120 deg Celsius i good
was it no hard at all to remove them when you have heated them?
did you use a mandrel (don't know if it is the right word) and a hammer to get them out when heated? did you not drill anything out of yours?