[targa911S]

whatever.
;-I


Twist drill
The twist drill bit is the type produced in largest quantity today. It drills holes in metal, plastic, and wood.
The twist drill bit was invented by Steven A. Morse[1] of East Bridgewater, Massachusetts in 1861. He received U.S. Patent 38,119 for his invention on April 7, 1863. The original method of manufacture was to cut two grooves in opposite sides of a round bar, then to twist the bar to produce the helical flutes. This gave the tool its name. Nowadays, the drill bit is usually made by rotating the bar while moving it past a grinding wheel to cut the flutes in the same manner as cutting helical gears.
Tools recognizable as twist drill bits are currently produced in diameters covering a range from 0.05 mm (0.002") to 100 mm (4"). Lengths up to about 1000 mm (39") are available for use in powered hand tools.
The geometry and sharpening of the cutting edges is crucial to the performance of the bit. Users often throw away small bits that become blunt, and replace them with new bits, because they are inexpensive and sharpening them well is difficult. For larger bits, special grinding jigs are available. A special tool grinder is available for sharpening or reshaping cutting surfaces on twist drills to optimize the drill for a particular material.
Manufacturers can produce special versions of the twist drill bit, varying the geometry and the materials used, to suit particular machinery and particular materials to be cut. Twist drill bits are available in the widest choice of tooling materials. However, even for industrial users, most holes are still drilled with a conventional bit of high speed steel.
The most common twist drill (the one sold in general hardware stores) has a point angle of 118 degrees. This is a suitable angle for a wide array of tasks, and will not cause the uninitiated operator undue stress by wandering or digging in. A more aggressive (sharper) angle, such as 90 degrees, is suited for very soft plastics and other materials. The bit will generally be self-starting and cut very quickly. A shallower angle, such as 150 degrees, is suited for drilling steels and other tougher materials. This style bit requires a starter hole, but will not bind or suffer premature wear when a proper feed rate is used.
Drills with no point angle are used in situations where a blind, flat-bottomed hole is required. These drills are very sensitive to changes in lip angle, and even a slight change can result in an inappropriately fast cutting drill bit that will suffer premature wear.